scotd1
Bronze Member
I have a JD609 rotary cutter that I have had for many years and last year I traded up to a JD5410 and kept the 609. I didn't think about it at the time but the 609 will not cut out my tracks with my tires in the wide position,which is where I keep them due to these Tennessee hills.
Now, I talked to my dealer about an 8 foot cutter and he recommends going to a pull type instead of the 3pth type. I have never used a pull type and thought they were only for relatively flat, open places. Dealer says they are better and easier on the tractor.
So, should I stay with the 3pth cutter or would I be better off with a pull type?
Now, I talked to my dealer about an 8 foot cutter and he recommends going to a pull type instead of the 3pth type. I have never used a pull type and thought they were only for relatively flat, open places. Dealer says they are better and easier on the tractor.
So, should I stay with the 3pth cutter or would I be better off with a pull type?