breakfasteer
New member
- Joined
- Mar 13, 2005
- Messages
- 3
Borrowed a friend's old Worksaver post hole digger (9-in. Auger, I think).
Mounted it on my Kubota B7510 (23 Horse),
Just spent an hour trying to get the post hole digger ( to bore a sample hole deeper than 4 inches. The proper pin hole is chewed up and the U angle piece welded onto the lifting arm of the Post Hole Digger, needs to be replaced and welded on. If we move the pin to a higher hole, then tilt the loader blade so that the tractor tips up, it can drill a bit deeper, but not deep enough for the eighteen foundation holes I need to drill, TOMORROW MORNING, for the deck. I don’t know how to fix this. Maybe the thing is too big for the tractor?
ANY QUICK ideas on how to get the auger to dig deeper?
Feel free to write breakfasteer@yahoo.com. . Pacific Time.
Thanks much!
Mounted it on my Kubota B7510 (23 Horse),
Just spent an hour trying to get the post hole digger ( to bore a sample hole deeper than 4 inches. The proper pin hole is chewed up and the U angle piece welded onto the lifting arm of the Post Hole Digger, needs to be replaced and welded on. If we move the pin to a higher hole, then tilt the loader blade so that the tractor tips up, it can drill a bit deeper, but not deep enough for the eighteen foundation holes I need to drill, TOMORROW MORNING, for the deck. I don’t know how to fix this. Maybe the thing is too big for the tractor?
ANY QUICK ideas on how to get the auger to dig deeper?
Feel free to write breakfasteer@yahoo.com. . Pacific Time.
Thanks much!