Bullzibart
Bronze Member
Thanks again... I believe its a IH 400 not 100% sure. Going to pick it up tonight after work.. Hopefully have it up and running this weekend.
American International Brush Hog
- Thread starter VTB
- Start date
MajMac, It is the same brand as in your photos, but I got the 5'. Seems to be ok. I hooked it up just fine and initial test runs through the pasture worked fine. But, when looking at it in the barn yesterday, I notice the two connector bars on the 3-point hitch are bent subtantially. Not sure how I did that. Didn't hit anythig hard. Hmmmm....
Also, I'm having a brain lapse and can't seem to remove the plastic PTO cover to get at the bolt securing it to the Gear Box.
It's the same PTO shaft that's in your picture. Any help would help!
Thanks a ton....
Also, I'm having a brain lapse and can't seem to remove the plastic PTO cover to get at the bolt securing it to the Gear Box.
It's the same PTO shaft that's in your picture. Any help would help!
Thanks a ton....
MajMac392
Gold Member
- Joined
- Jan 8, 2002
- Messages
- 406
- Location
- Southern Maine
- Tractor
- Cub Cadet 7234, John Deere X300 Riding Lawn Mower
VTB, I haven't taken the plastic sleeve off yet so I'm not sure. I've wondered though because I think the u-joint has a grease fitting and I've not sure either how to remove the plastic. I copied the Op. manual to a .pdf at work today but this site kept telling me the thing was to big a file. It is only 408K or so, not big in my mind but I was unable to attach it.
MajMac392
Gold Member
- Joined
- Jan 8, 2002
- Messages
- 406
- Location
- Southern Maine
- Tractor
- Cub Cadet 7234, John Deere X300 Riding Lawn Mower
Can anyone tell me how to attach a file to a post. When I try, even a small file, 408K .pdf, it tells me it is to big. I sent an email to "Contact US" but no reply. Thanks in advance.
Bullzibart
Bronze Member
MajMac do you have a website for them? I can't seem to find anything about them online.
I looked at your brush hog in the photos and mine is alot different. You have the two supports that run from the 3pt. hitch back to the rear. Mine has what looks like a piece on leaf spring with a small amount of chain on the end.
I hope you can figure out how to attach that file, and I hope it will help me some.
I looked at your brush hog in the photos and mine is alot different. You have the two supports that run from the 3pt. hitch back to the rear. Mine has what looks like a piece on leaf spring with a small amount of chain on the end.
I hope you can figure out how to attach that file, and I hope it will help me some.