Results 1 to 5 of 5
  1. #1

    Join Date
    Mar 2006
    Posts
    1

    Default Covington Cutter

    I purchased A 5' Covington Cutter. The problem is that There is no slip clutch or shear bolt arrangement on the drive shaft. Is this safe? The cutter has a 1 3/8 spline shaft as does the tractor.

  2. #2
    Platinum Member
    Join Date
    Jun 2000
    Posts
    521
    Location
    Central Mississippi, USA
    Tractor
    Case-International 385

    Default Re: Covington Cutter

    I have an old Covington cutter that I junked a few years ago. It also had no gearbox protection. I used it for about 25 years and cut many 2"-3" sapplings and never hurt the cutter or the tractor(s). I'm not saying this is the wise way to go, but just my experience.

  3. #3
    Advertiser sweettractors's Avatar
    Join Date
    Jul 2003
    Posts
    7,147
    Location
    Central Kentucky
    Tractor
    JD 6403 CHA-JD 3130 CHA

    Default Re: Covington Cutter

    If you need one? We have the new clutch that would go on the 1 3/8 inch diameter-6 spline shaft--Ken Sweet
    Email: sweet@scrtc.com

  4. #4
    Veteran Member
    Approved Advertiser
    HayDR's Avatar
    Join Date
    Oct 2002
    Posts
    1,864
    Location
    Johnson City, TN
    Tractor
    JD 2040,2240, 2355, 2755, 4055

    Default Re: Covington Cutter

    Check out CCM- "PTO Shaft Headquaters"

  5. #5
    New Member
    Join Date
    Jul 2009
    Posts
    1

    Default Re: Covington Cutter

    I own a Covington cutter. Was built I think in the 50's. I need to replace the bottom seal, but I can not find any numbers on the seal. Please help.

    Bruce

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© 2013 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.