rdln
Veteran Member
They can aslo be used (very carefully) to breakup to remove old sidewalks.
Middle Buster & Subsoiler
- Thread starter MikePA
- Start date
EdDekker
Silver Member
- Joined
- Apr 11, 2000
- Messages
- 191
- Location
- New Ipswich, New Hampshire
- Tractor
- Kubota B2400, Bobcat 331 Mini-Excavator
I have a combo unit (from Northern). It is now set up as a middle buster and if/when I change it to a subsoiler I will have to replace the plow bolts which hold the blade to the shaft. They rusted in place within a few weeks of the first time I used the middle buster. I should have applied a thick layer of anti-sieze (or some type of heavy grease) when I assembled it.
Ed
Ed
Buck
Platinum Member
Alan,
Thinks are the same all over. I hope your wife didn't catch you. Mine's asleep.
Buck
Thinks are the same all over. I hope your wife didn't catch you. Mine's asleep.
Buck
jrdellaratta
Silver Member
What would be the minimum tractor horsepower required to effectively use either of these units, to ultimately get 12"-14" deep?
cedarranch
Silver Member
It has been my experience that HP is not an issue. I have seen 18hp Yanmars do just fine with a middle buster. I use a 25hp zetor with one. What matters is the amount of traction. You may have to weight the tractor down to keep it from spinning. My neighbor with the yanmar had to fill his tires with CaCl to get the traction thru his hard ground. I have weights and antifreeze in mine.