project_X
Gold Member
Post Hole digger won\'t go deep enough???
I have a Worksaver posthole digger and due to the geometry of my Yanmar 1602D, I can only dig a hole about 36"deep. I took a look at setup, there appears to be a couple of different solutions.
1. Build a new plate(s) to hold the top link to the tractor that is taller, moving the tractor end of the lever vertically 6" or more. There is lots of room for this, and I belive that the mounting point can be built with sufficient strength.
2. Make an adapter to extend the length of the post hole digger.
3. Add holes to the lower link arms to lower the digger. I don't think that enough depth is available through this method.
Any other solutions, advice,.......
Thanks,
Rob
I have a Worksaver posthole digger and due to the geometry of my Yanmar 1602D, I can only dig a hole about 36"deep. I took a look at setup, there appears to be a couple of different solutions.
1. Build a new plate(s) to hold the top link to the tractor that is taller, moving the tractor end of the lever vertically 6" or more. There is lots of room for this, and I belive that the mounting point can be built with sufficient strength.
2. Make an adapter to extend the length of the post hole digger.
3. Add holes to the lower link arms to lower the digger. I don't think that enough depth is available through this method.
Any other solutions, advice,.......
Thanks,
Rob