Bagger Install

   / Bagger Install
  • Thread Starter
#11  
It's hooked in the lower lift arms, just tilt it forward and insert the top link pin and connect the PTO.
 

Attachments

  • Ready2Hk6.JPG
    Ready2Hk6.JPG
    81.9 KB · Views: 423
  • Ready2Hk7.JPG
    Ready2Hk7.JPG
    86.6 KB · Views: 398
  • Ready2Hk8.JPG
    Ready2Hk8.JPG
    87.7 KB · Views: 414
   / Bagger Install
  • Thread Starter
#12  
All ready to suck. Don't forget to raise the stands, did that once.:D
 

Attachments

  • Ready2Hk9.JPG
    Ready2Hk9.JPG
    74.7 KB · Views: 532
  • Ready2Hk11.JPG
    Ready2Hk11.JPG
    74.4 KB · Views: 466
  • HoseOn1.JPG
    HoseOn1.JPG
    96.7 KB · Views: 492
  • HoseOn2.JPG
    HoseOn2.JPG
    89.6 KB · Views: 495
   / Bagger Install
  • Thread Starter
#14  
Sorry about the long delay, I have the Kubota bagger, and I like the way it works, several have complained about it being a bear to put on, but before I made the mods, I had it on and off a couple of times and after a little practice, it's not that bad. One of the main reasons I went with this one is that it is powered by the PTO, no extra gas engine, so much quieter that way.
 
 
 
Top