rmorgan
Gold Member
- Joined
- May 1, 2001
- Messages
- 336
- Location
- Summerside, OH
- Tractor
- NH TC33D; RTV900; Gravely Professional
I finally bought the 3-point splitter I've thought about for awhile, and have a question about the hydraulic setup on my TC33D. The rear remote is controlled by a lever which returns to center (closed) after being moved either fore or aft. The splitter, of course, has its own hydraulic lever. The splitter is only powered when the lever on the tractor is open, at which point the splitter hydraulic control works normally. If I was to keep the remove open and control flow only on the splitter, would I be putting inappropriate stress on the system? And in the long run, what do I do to address this so's it works the way it should?
Thanks!
Thanks!