jd #44 plow shares

[Gizmo36]

On a MT the Drawbar HP was 14.08 Engine was 18.33 HP The weight is 2,550 lbs Now my Yanmar is Engine 25 HP the weight is 2083 It weights 467 more then my Yanmar 2210 The MT is 125 long The 2210 Yanmar is 110 The MT is 15" longer, that is a lot when it comes to a tractor . Now I know from years ago that the MT would pull the 2/14 easy. Now I no the newer one's pull like a anchor .I put it to the 2210 and it pull it easy in hard clay. Now when I am done and it is a 3 pt .It may pull like an anchor we will see. .When I get done I may have a peace of junk it may not pull too good .Farmwithjunk the one he has the shin and the moldboard is one peace I think.

 

[troweller]

my plow is 2 piece(share and moldboard)
there is one hole for a plowbolt towards the rear, a nipple in the middle, a slot near the point.

 

[troweller]

here are some pictures of the plow

 

[Gizmo36]

This is the way your plow look at one time .Some one has done the same thing I am doing.I wish I had saw your plow before I started on my plow . I would have use the bent piece at the end like they did .

 

[troweller]

still looking for plowshares for my 14 inch plow, John Deere does not make them anymore, where can i find these?

 

[richard mosher]

Gismo. I am working on an 8 furrow steam engine plow. I need 8 BC250 shares. Can you help?

 

[Gizmo36]

I gave a load of them away , I don稚 think I have any more I can look . if you want the man痴 name and phone number I cam pm it to you if you want.