JohnInCA - As you know, I had a Bradco 609 installed on a Kubota L4310 (and an L3650, I think, before that), so my experinece may not be at all applicable, but I did have a similar situation. What I had to do was simply loosen the sway adjusters so the side links would swing closer to the center - then I could raise the side links up out of the way completely. This was a bit of a pain with the L3650, because of the turnbuckle adjusters, which were frequently bent because of the way I abused them, but with the L4310, I could just lift the two pins out of the holes (I threw the clips that locked them in place in the tool box the second day I had it), swing the side links all the way in, drop the pins back in, and I was done.