When I replace panl

   / When I replace panl #1  

Bvill01

New member
Joined
Mar 24, 2012
Messages
18
Location
Tx
Tractor
S220 bobcat loader
When I replace panel(keyless) start do need to reprogram or just install? Replacing it with keyless panel
 
Last edited:
   / When I replace panl #2  
When installing or replacing a keyless panel all you need to do is press and hold the run enter button for about 5 seconds until it gives a beep and the panels light up. No need to re-enter the password(s) they are stored in the main controller.
Note: I should clarify, this is for a loader (skid or track). If it is an excavator or toolcat there are other procedures required.
 
   / When I replace panl
  • Thread Starter
#3  
Thank u all try that
 
 
Top