If anyone else has this mower and are curious it's a Comer Industries gearbox, closest to the LF205-J, it is reversible, note that the center is offset 79mm on one side and 83mm on the other. When you flip the bevel input gear to the rear side facing forward, take the three spacers that were at the rear between the bearings and the oil cap and switch sides with the two at the front behind the spline shaft seal otherwise you will have absolutely no play and it will overheat as I found out. Make sure you've ever so slight play before reassembling. Avxseals.com.com is near 1500% cheaper than Bobcat as you will need new seals on either side.