welder_kid_6
New member
- Joined
- Nov 8, 2008
- Messages
- 8
:hi guys im looking at building a bobcat/skidsteer. i have been thinking something along the lines like this . two rear car diff's linked together with a sprocket welded on the bar that links the 2 diff's together. a 4 cyl engine mounted backwards on the back with a sprocket welded on the end of the gear box. a chain will link the engine and gearbox to the diff's. it will turn by braking one side of each diff.
dose this sound good or what??? got any idea's to make it better
the diff's with the wheels on them are about 5ft or 1500mm long are they to long to use???? should i try and shorten them?? if so how do i go about it??
what would be better to use a manule (spelling???) or auto gear box??
if the man gear box i would have to use clutch try and turn and use the bucket all at the same time and all that sounds a bit hard so what would be better???
this would just be the base bit then i would and the FEL bit and so on so any idea's would be great and i have like 10 cars to get bits off thanks john
dose this sound good or what??? got any idea's to make it better
the diff's with the wheels on them are about 5ft or 1500mm long are they to long to use???? should i try and shorten them?? if so how do i go about it??
what would be better to use a manule (spelling???) or auto gear box??
if the man gear box i would have to use clutch try and turn and use the bucket all at the same time and all that sounds a bit hard so what would be better???
this would just be the base bit then i would and the FEL bit and so on so any idea's would be great and i have like 10 cars to get bits off thanks john