Cutting Torch Tips.

EdKing · 08-12-2002, 07:19 PM

I got a question for all you weldors out there. I just got a good deal on some cutting tips for my Oxy/Propane torches. I got 4 each size 4/0 and 5/0 tips and was wondering what the cutting capicity is for these size tips. I searched quite a bit on the net and couldn't find any info.

Thanks in advance,

ronjhall · 08-13-2002, 04:41 AM

Ed
It depends on what manufacture made your tips. Check out this <A target="_blank" HREF=http://www.arcsmith.com/ntt/default.htm>SITE</A> . Their catalog list the different manufactures and thickness each tip will cut.

EdKing · 08-13-2002, 06:24 AM

Thanks Ron, I have a Harris torch. They list the 4/0 as 1/4", but not the 5/0. I guess it is just a little thinner capicity.

08-12-2002, 07:19 PM	#1 (permalink)
EdKing Platinum Member Join Date: Jan 2002 Location: South West Pa/Greene county Posts: 854	Cutting Torch Tips. I got a question for all you weldors out there. I just got a good deal on some cutting tips for my Oxy/Propane torches. I got 4 each size 4/0 and 5/0 tips and was wondering what the cutting capicity is for these size tips. I searched quite a bit on the net and couldn't find any info. Thanks in advance,

08-13-2002, 04:41 AM	#2 (permalink)
ronjhall Super Member Join Date: Apr 2000 Location: Southeast Michigan Posts: 5,272	Re: Cutting Torch Tips. Ed It depends on what manufacture made your tips. Check out this <A target="_blank" HREF=http://www.arcsmith.com/ntt/default.htm>SITE</A> . Their catalog list the different manufactures and thickness each tip will cut.

08-13-2002, 06:24 AM	#3 (permalink)
EdKing Platinum Member Join Date: Jan 2002 Location: South West Pa/Greene county Posts: 854	Re: Cutting Torch Tips. Thanks Ron, I have a Harris torch. They list the 4/0 as 1/4", but not the 5/0. I guess it is just a little thinner capicity.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode