Just wanted to post a pic of the forklift attachment I made for my loader. The forks are just made from 4" channel and I expect them to give some. Tried it out today and was suprised at how well it did. Moved some 3' x 20' metal roofing that had been covered with kool seal. Each sheet weighs between 50 to 80 pounds. I moved between 5 to 10 pieces at a time and nothing broke. Anymore than that and it would lift the rear of the tractor. I am real pleased with how they perform and I built them for less than $75.00. Not bad for an ole country boy from Alabama.