204saskman
Gold Member
Well after reading " The Haymakers" thread on his snow pusher build it make me think about building one. So i had some thin metal bent up(12gauge or 1/8") but figured it was to thin as it just warped to easy(twisted). So i called the local machine shop and asked them when they could bend me some metal. I went in today and they did it while i waited. Had it all bent up out of 1/4" Metal(bought a whole 4'x8' sheet). I had them sheer it at 24"x 72" and then had them bend it at 6" down on both ends at a 45* angle. There is 12" center on but i had them bend up a 4"x4" angle to brace the bottom. I also had them sheer up sides with knotched corners and the sides are 24"x24". I have an old grader blade with a brand new edge on it. Im going to have to brace it up a bit on the back like a back bone but i should be into the balde for under 500 when all said and done. I will post some pics up tonite. Im also going to attempt my luck at building a SSQA for it too.