Results 1 to 2 of 2
02-19-2012, 10:09 AM #1
- Join Date
- Oct 2007
Drip line plow
This one is a plow I built for installing irrigation drip lines. The machine is built from 4x4x3/16 box tube with ½" steel plate doublers on top and bottom of the rear blade mount. 5/8" holes equal spaced allow for just about any spacing between installed lines.
The spools have ½" hyvar bolted to the cross bars to act as bearings and simple pvc pipe spacers to keep it simple.
The blades are just riper blades from a box blade with 1/8 steel plate welded to make a channel for the drip line and a generous radius so it won't kink.
I have an extra 3 point attachment left over from another project that I intend to make a single ripper like this one but to run/bury cable quicker than my trencher?hen I get around to it.
Last edited by jwmorris; 02-19-2012 at 10:38 AM.
02-19-2012, 10:23 AM #2
- Join Date
- Nov 2007
- Windsor, CT.
- L3240GST, B2320HST, B5100D & G5200H
Re: Drip line plow
Gawwwwwwwww. That's beautiful.That's the problem with trouble.
It always starts out as such fun."
- Randall Brown
By inveresk in forum AttachmentsReplies: 10Last Post: 09-07-2013, 11:55 PM
By roaf3x in forum Kubota Owning/OperatingReplies: 1Last Post: 04-04-2011, 10:55 AM
By Doc_Bob in forum AttachmentsReplies: 10Last Post: 12-02-2006, 09:22 PM
By wroughtn_harv in forum ProjectsReplies: 100Last Post: 10-18-2006, 08:11 AM
By drm in forum ProjectsReplies: 38Last Post: 07-28-2005, 09:22 AM