njc110381
Member
Hey guys. I'm quite keen to make a few implements for my tractor but don't really know where to start. I need a loader but I think that's perhaps a bit complicated, so I'm thinking of making a saw bench. Has anyone done this? I know the old models with the free blade sticking up through a table were pretty dodgy but the modern ones look very good. I have a friend who uses one on his MB Trac and it really flies through whatever you feed it.
The only thing I'm a bit stuck on is the gearbox and the 90 degree turn that the power has to make so as the logs can fall to the side of the tractor. If I make it in line then the seat will get in the way of the longer logs.
I tried to search but "saw" is too short for the search facility so I didn't come up with much.
The only thing I'm a bit stuck on is the gearbox and the 90 degree turn that the power has to make so as the logs can fall to the side of the tractor. If I make it in line then the seat will get in the way of the longer logs.
I tried to search but "saw" is too short for the search facility so I didn't come up with much.