Deere Dude said:That brings back memories. :thumbsup::thumbsup:I built one similar to that at work and let the opening hang over the end of my desk. I had quite a few people from all over the factory save their cans and bring them up to be able to put them in and hit the knob and watch it crush a can in half a second and drop into the box. Of course I took the aluminum home. One co-worker was going to catch his can so he put his hand under the chute a little to close and when the ram came back it pinched his finger a good one.:cool2: Nothing broken but got his attention.
It is cut-out. Notice picture 1. I know its kinda dont look like it cause its setting on a stainless bench. But where the angled VEE shape stops, is the end of the bottom.
This isnt the first one of these I have made. I just bolt them to the workbench, Let the end hang over about 6", and place a barrel underneath. Cans fall out very nicely.:thumbsup:
Makes for rapid crushing! :jump: