rockinmywaypa
Platinum Member
- Joined
- Jul 10, 2003
- Messages
- 656
- Tractor
- john deere 3130, universal case 970 and a IH 1086
I would like to take an engine that was on a swather with a variable belt drive and convert it to drive a pto shaft. I would like to have a clutch while eliminating the belt. Does anyone know of anything that would suit the purpose as a clutch and stand up to about 40 hp input. The application is to mount the motor in front of a tmr mixer wagon by extending the tongue so that I can move it with the same tractor that I load it with and then can start it up to unload later in the day and not have to start up an 80 hp diesel in sub freezing weather. I am hoping I can come up with a straight through design instead of side stepping out and back with pulleys but I can if I absolutely have to.
Thanks in advance.
Thanks in advance.