Pics of my newly built snow pusher

[JLwoodworks]

Hello all,

Id like to share some pictures of the snow pusher i just built. Its my first one. What do you think?

Jay

[/url]snow pusher by Jason, on Flickr[/IMG]

[/url]snow pusher by Jason, on Flickr[/IMG]

[/url]snow pusher in primer by Jason, on Flickr[/IMG]

[/url]snow pusher is complete by Jason, on Flickr[/IMG]

[/url]snow pusher is complete by Jason, on Flickr[/IMG]

[/url]snow pusher is complete by Jason, on Flickr[/IMG]

[/url]snow pusher is complete by Jason, on Flickr[/IMG]

 

[oldpilgrim]

beautiful work........

 

[vacman]

I think it looks fantastic. You did a really nice job building it. Now all you need is snow.

 

[groundcover]

Nice build !

 

[300UGUY]

Nice job. You are a pretty good fabricator.

 

[jack707]

LOOKS GOOD!.

 

[Rustyiron]

Hello all,

Its my first one. What do you think?

Jay

I think you did a FINE job!:thumbsup:

 

[JLwoodworks]

Thanks guys.

The ends are 1/4, the mold board is 3/16. skis are 5/8. Cutting edges are 1x6" rubber, all hardware is 1/2" stainless with nylock nuts.
I have about $900 into it and a total of 22hrs fab time including bending and shearing at my friends shop, and painting it.

Jay

 

[Rustyiron]

Where did you find the rubber edge(s)?

 

[JLwoodworks]

Home - Plow Rubber easy enough right? Haha
They are in buffalo only a little over an hour from me. $114 for each cutting edge. Not too bad. I think it was about 275 for the pair shipped.