pappy60
Member
As part of a fundraiser we have to put up about 15-20 standard fence t-posts then remove them and put them back up in a different location.
This is a yearly event... possibly to become twice yearly..
We cannot use a tractor due to location... Have been using manual driver (homemade version of this...
...cannot get any link to work... go to either tractor supply or northern tool and check their "fence post driver"
But we are not getting younger so looking to make something that can either run off electric or small lawnmower sized engine to drive the posts into the ground..
Have not come up with a working solution...
Need ideas on how to build something... something like a small jackhammer, etc...
Need cost to be low, but have plenty of steel available and all tools to make just about anything in this size.. i.e. welders, torches, saws, etc.
Any advice or ideas ??
All help greatly appreciated.
This is a yearly event... possibly to become twice yearly..
We cannot use a tractor due to location... Have been using manual driver (homemade version of this...
...cannot get any link to work... go to either tractor supply or northern tool and check their "fence post driver"
But we are not getting younger so looking to make something that can either run off electric or small lawnmower sized engine to drive the posts into the ground..
Have not come up with a working solution...
Need ideas on how to build something... something like a small jackhammer, etc...
Need cost to be low, but have plenty of steel available and all tools to make just about anything in this size.. i.e. welders, torches, saws, etc.
Any advice or ideas ??
All help greatly appreciated.
Last edited: