JRP
Platinum Member
Share your "build it yourself" sprayer photos on this post.
I built this spray boom. The design requirements were:
1. No tools to install.
2. Folds if you hit something.
3. Spray with center section or all three sections
4. Fit in a pickup.
5. Light enough for one man to handle.
6. This one is 21' unfolded.
7. Proper spacing and heigth - minimal drift, good coverage.
8. Uses standard Tee-Jet components.
This is the sprayer tank. I added an angle frame with two wooden hooks. Hooks are suppost to break before the boom bends. I need to paint this.
I built this spray boom. The design requirements were:
1. No tools to install.
2. Folds if you hit something.
3. Spray with center section or all three sections
4. Fit in a pickup.
5. Light enough for one man to handle.
6. This one is 21' unfolded.
7. Proper spacing and heigth - minimal drift, good coverage.
8. Uses standard Tee-Jet components.
This is the sprayer tank. I added an angle frame with two wooden hooks. Hooks are suppost to break before the boom bends. I need to paint this.