Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12
  1. #11
    Gold Member
    Join Date
    Nov 2005
    NH TN70D, NH L190

    Default Re: The ""THUMB""?

    I bought a "Thumb" a few years ago and it sat unused until last year. Chopper, yes there are pre-drilled holes in the base plate.

    Last year I bolted a 3"X3"X1/4" angle to the uprights on my pallet forks, then bolted the thumb to the angle. The set-up really works well. I use the forks (with thumb) on my tractor and on my skid loader. On the skid, it made short work of wrecking out an old wood frame building with metal siding and roof. I took the roof off, laid the sides down and stripped the metal skin off of the wood framing without getting off of the skid loader. Buried the wood in a burn pit and took the metal to the scrapper.

    The thumb was an excellent purchase.


  2. #12
    Super Member kenmac's Avatar
    Join Date
    Feb 2005
    The Heart of Dixie
    Yanmar3110D, Kubota MX 5100 HST, Kubota ZD1021, Kawsaki Mule 4010 trans 4x4

    Default Re: The ""THUMB""?

    I had my thumb bolted to the top of my bucket. here's a thread where I moved it ut in front of my bucket. You have to brace the bucket or, you'll end up with a bent bucket
    A Fredricks Yanmar 3110D
    07 Dodge 2500 5.9 Cummins
    Husky 372xp
    Husky 55 Rancher
    Maruyama trimmer
    Husky trimmer
    Redmax BP blower
    Toro zero turn
    North Star 4 K PSI pressure washer
    Honda 300 4 trax
    Yamaha Timberwolf
    liquid logic coupe kayak
    16' Tow Master Dump Trailer ,20' Yanmar Hauler

Page 2 of 2 FirstFirst 12

Similar Threads

  1. RVS "Rear View Safety" Camera install short review "pics"
    By Jamming in forum John Deere Owning/Operating
    Replies: 13
    Last Post: 03-19-2012, 10:00 AM
  2. Replies: 0
    Last Post: 08-20-2011, 08:34 AM
  3. Diff. between "Cold Finish" & "Hot Rolled" steel?
    By beppington in forum Welding
    Replies: 23
    Last Post: 03-03-2011, 07:45 PM
  4. Replies: 0
    Last Post: 02-08-2011, 01:46 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
© 2018 TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.