Results 1 to 2 of 2
05-01-2010, 11:17 AM #1
- Join Date
- May 2010
I have a Case 580 SK and am trying to replace the coupler. This is attached to the dipper with two bushing. I cut them with out with cut off saw but would like to know how to remove them from the dipper. I think they were pressed in. I tried hitting them out but no luck. Any advice is appreciated.
05-01-2010, 07:23 PM #2
- Join Date
- Oct 2004
- limerick pa lycoming county pa
- kubota bx23
Re: Replacing Bushings
I'm not sure what the coupler is?
Were the bushings bronze?
pictures are worth 10,000 words
picture posting link
if you slotted the busing it should slide right out with a couple taps with a punch and hammer.
Some times there is a bolt or pin or grease fitting catching on them.
tomIf it ain't broke we will help you brake it
If it is broke we will help you get it fixed!
By Matt in TN in forum New Holland Owning/OperatingReplies: 8Last Post: 08-18-2013, 05:28 PM
By dourobob in forum Build-It YourselfReplies: 25Last Post: 06-13-2010, 09:03 PM
By chuck1764 in forum Parts/RepairsReplies: 4Last Post: 01-13-2010, 07:53 PM
By Bill_C in forum Trailers & TransportationReplies: 1Last Post: 08-30-2008, 07:06 AM
By MarkV in forum Construction EquipmentReplies: 5Last Post: 05-05-2007, 10:34 AM