Blower is 63 " CaseIH as is cab ,also have mower deck , tiller and loader - all CaseIH.Blower is quik attach. Flip a lever , unhook pto shaft and quick plug wire harness for electric chute rotation and chute raise /lower. Subframe quick hitch stays on if you have front blade or broom . I found better to take subframe off for loader , 2 pins and 2 hyd hoses just unplug quick couplers. also uncouple pto from trans/ rear end. loader brackets stay on year round.Blower on or off 5 min max. Subframe 5 min. .Loader on/off 5min.Loader needs to be on to install / remove midmount mower - 5 min as well. mower is too wide too roll out from under tractor , use loader to lift front end in air then roll deck in or out.Dealer installed cab , I haven`t had off yet but last 2 years I had a DX24E with same setup except loader and cab would take approx 1 hour to install / remove. I traded up to DX26 when I wanted loader to get much increased lift.
I gained alot of loader lift going from DX24E to DX 26 . By times could use more loader capabilities but only have 1 acre here to mow and 2 acre cemetary. Wouldn`t want alot bigger , heavier tractor at cemetary and a wider deck wouldn`t fit very well between stones . Went from side discharge to rear discharge as well , both mid mount. rear discharge does much nicer job , wheels are better , doesn`t leave any visible residue of blow it all over stones .