I finally took some photos of the chainsaw holder that I have mounted to the FEL post on my new Montana. I fabricated it out of aluminum L channel and plastic from a kitchen cutting board. The saw is now always in an out of the way, easy to reach location. It does not rattle at all and the cutting teeth are well protected. Greg
Chainsaw holder
- Thread starter gpd9780
- Start date
emmy71
Silver Member
Hope you don't mind, but I am stealing that idea.
Terry
Terry
RobA
Platinum Member
Nice job. How is it mounted to the FEL post?
Hello
The unit is mounted using (6) 2 1/2" x 1/8" stainless bolts which go through the aluminum, then plastic, and spacers on the back side. I drilled through the frame and put nuts on the back where I could access and tapped the ones I could not access. Greg
The unit is mounted using (6) 2 1/2" x 1/8" stainless bolts which go through the aluminum, then plastic, and spacers on the back side. I drilled through the frame and put nuts on the back where I could access and tapped the ones I could not access. Greg
rtdiggr
Platinum Member
Great idea. i my have to "borrow" that idea myself.
Shane
Shane
Aquaman
Silver Member
- Joined
- Dec 2, 2007
- Messages
- 187
- Tractor
- Kubota BX24
Excellent idea. Too bad so many people are stealing it. Uh....I gotta go out to the shop now........
MikesTractor
Silver Member
Nice Job! I like how the plastic protects the chain..........Now where did I put that cutting board?
3RRL
Super Member
- Joined
- Oct 20, 2005
- Messages
- 6,825
- Tractor
- 55HP 4WD KAMA 554 and 4 x 4 Jinma 284
Yes, very nice idea and clean fabrication.
Now to check out where to mount mine...
Now to check out where to mount mine...
DirtyWorks
Silver Member
- Joined
- Apr 16, 2007
- Messages
- 203
- Location
- Mississippi Pine Belt
- Tractor
- ASV RC-100, '07 272c Cat ,Kubota 080 with Cimaf Head, Cat 257 MTL, JD 450c, Kubota 3440 4wd CUT w/ fel
Sweet! Need one like that on my chipper! Great Fab
streamin
Gold Member
Greg, that is a great idea !! I just was thinking about that today, but I think I will go 1 step further and add a stepdown slot because I have 2 saws I use at the same time(smaller).The other side will have a chain holder I saw in another thread.Thanks for posting pics!