Pa Pa Jack
Silver Member
I had time today to check out the chain. It does seem to me that one side is a little duller than the other side. I sharpened it and went to reinstall it. I noticed some of the pawls that catch the drive sprocket would not go into the bar slot without a little effort. It seems that they have a bur on them. Is there some simple way to burnish these burrs off? Is that normal? I checked the other chains I have that need sharpened, and they also have burs in the same place. They will not easily go into a brand new bar I have sitting on the shelf. I can only believe that this is not good. The drive sprocket shows slight wear, but I would think that is normal after cutting several cords of wood.