DF-354 lift arms not parallel....did I break something?

[mpaschetto]

I've got a 2004 DF-354, and this weekend I noticed that the two
lift arms at the rear of the tractor are not level with one another?

Don't the arms share a common splined shaft inside the housing?
If not, is there a way to adjust them to be parallel with each other,
or have I broken something?

TIA,

Mike

 

[greenmule]

Yeah,there is an adjustment on them,one side at least should screw up and down.

 

[bluechip]

If the arms at the top are uneven, it could be assembled wrong or the shaft could have been twisted. the top arms are held to the shaft by splines. you could try removing one and reinstalling to match the other one.

 

[mpaschetto]

Thanks guys,

Hopefully, the shaft is not twisted!

In any event, I will try to reposition one of the arms this weekend, and see if I can get them parallel with each other...

Mike