ToolManRick
Silver Member
No \"glow\" Glow Plugs
Any idea on what might cause all three glow plugs, that have never really been used, to fail?
When I first got my Jinma 204 (Nortrac 204C) it did have an amperage draw when the switch was in that position. And admittedly that is no guarantee that all three were working even back then. I still have voltage at the glow plugs, but they show "open" on the ohm meter. When I get home this evening I'll actually remove them from the engine and give'm a visual check. Just curious as to what may have caused their failure.
Pretty sure Northern Tool will stand by the guarantee. I'll give them a call later on today after I do the visual 12 volt glow check.
Thanks guys.
Any idea on what might cause all three glow plugs, that have never really been used, to fail?
When I first got my Jinma 204 (Nortrac 204C) it did have an amperage draw when the switch was in that position. And admittedly that is no guarantee that all three were working even back then. I still have voltage at the glow plugs, but they show "open" on the ohm meter. When I get home this evening I'll actually remove them from the engine and give'm a visual check. Just curious as to what may have caused their failure.
Pretty sure Northern Tool will stand by the guarantee. I'll give them a call later on today after I do the visual 12 volt glow check.
Thanks guys.