The spin on Suction strainer is from Northern Tool:
http://www.northerntool.com/webapp/wcs/stores/servlet/ProductDisplay?storeId=6970&productId=24414&R=24414
The Fittings are
2, Straight Swivel adapters 3/4"male NPTF x 3/4" Female Swivel NPSM (Northern 51ASC012)
1, 90* Swivel adapter 3/4" x 3/4" Northern 51ARC012
1, 3/4" x 3/4" Female coupling Northern 51CSF012
1, 3/4" x 3/4" Male Coupling Northern 51CSM012
1, 1/2" male X 3/4" female reducer Northern 51CSC128 (this is what I used to weld on to the Chinese Pipe to convert to SAE) You must cut & weld the Chinese Pipe - must be a good gas tight weld ! I used MIG .023 wire with 75% Argon 25% Carbon Dioxide @ 70 amps very slow wire feed.
1, 3/4" Hydraulic hose with 3/4" NPT Male Fittings about 18-24" ? Long (Measure for your application)
Rubberized Gasket material
3/8" to 1/2" thick flat bar or plate steel about 3-1/2" square to make the adapter plate. This was home made in my basement shop with a band saw, drill press, grinder, & my 3/4" NPT tap. I just traced the old suction strainer plate onto the flat steel. And used a transfer punch to center the mounting holes. Very simple fabrication with basic tools. (Except for the MIG) Which I purchased from Harbor Freight reconditioned for an outrageous low price. Must have been someone who couldn't figure out how to use it and sent it back.
Anyway hope this helps.
Larry