Results 1 to 3 of 3
  1. #1
    New Member
    Join Date
    May 2013
    Posts
    2
    Location
    miami
    Tractor
    Club Cadet LT1045

    Default Wont run under load after replacing drive belt

    I own a Cub Cadet LT1045, replaced the drive belt and it ran under load for approximately 1 minute. I got it back started by feathering the choke, ran at low idle for several minutes, increased rpm's to full, still ok, engaged forward gear and it stalled after several seconds. Fuel is good, oil the same. I did have it standing on its tail as I did the repairs. I've read other threads, don't know if I messed up the timing or how that could occur. Just pulled off the clutch assembly, bent the keeper tabs open to install the belt, then put the clutch back on.

    Thank you for your help.

    Rick

  2. #2
    Platinum Member savageactor7's Avatar
    Join Date
    Sep 2008
    Posts
    571
    Location
    CNY

    Default Re: Wont run under load after replacing drive belt

    Good morning, try jacking up the rear wheels just off the ground and after the engine has warmed up try some back and forth peddle action. That might clear up any air bubbles in the system...if that is the problem.
    Kubota B1750 with chains on all 4 turf tires. CC1440 & GT2550

  3. #3
    New Member
    Join Date
    May 2013
    Posts
    2
    Location
    miami
    Tractor
    Club Cadet LT1045

    Default Re: Wont run under load after replacing drive belt

    Thank you....pulled the carb, cleaned and did what you suggested. Tractor is running without stalling.

Similar Threads

  1. PTO BLOWS FUSE AFTER REPLACING DRIVE BELT ON LT 1042
    By bamaman01 in forum Cub Cadet L&G
    Replies: 2
    Last Post: 07-21-2012, 05:31 PM
  2. Replacing PTO Drive Belt - SLT1550
    By IADave in forum Cub Cadet L&G
    Replies: 8
    Last Post: 06-24-2012, 09:38 AM
  3. Help with replacing the drive belt on LX188
    By joshfcb in forum John Deere Lawn & Garden
    Replies: 2
    Last Post: 08-13-2011, 02:09 AM
  4. Replacing a drive belt
    By crashzx2102 in forum Parts/Repairs
    Replies: 0
    Last Post: 04-27-2006, 09:39 PM
  5. replacing drive belt for John Deere model 116
    By rickers in forum Parts/Repairs
    Replies: 0
    Last Post: 07-07-2003, 09:30 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© 2016 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.