Results 1 to 3 of 3
  1. #1
    Member
    Join Date
    May 2012
    Posts
    33
    Location
    Section Al
    Tractor
    cub LT1042

    Default cub Lt 1042 clutch wires

    Does anyone know the gauge wire to wire up the clutch? Got a broke one.

  2. #2
    Platinum Member
    Join Date
    Mar 2008
    Posts
    590

    Default Re: cub Lt 1042 clutch wires

    typical elect PTO draws around 4-6 amps - would think 12-14 ga wire should be enuff....
    Got yer manual ?

  3. #3
    Bronze Member
    Join Date
    Apr 2013
    Posts
    58
    Location
    continental us
    Tractor
    all

    Default Re: cub Lt 1042 clutch wires

    usually when you pull of the deck,sometime's you need to BACKOFF ,the belt guard to remove the belt if you completely removed the guard but did not install it so the guard goes in the clutch slot the clutch will spin and pull out the wires,if you are lucky you can resolder the wire to make work .12-14 ga should be fine if you need to ad wire

Similar Threads

  1. LT 1042:Cub belt problems
    By bamaman01 in forum Cub Cadet L&G
    Replies: 1
    Last Post: 05-21-2013, 10:14 PM
  2. PTO Clutch on a Cub 2206
    By rwwilly in forum Parts/Repairs
    Replies: 1
    Last Post: 05-05-2013, 10:05 PM
  3. Cub 7260 Clutch Replacement
    By BBSTEIN2 in forum Cub Cadet Tractors
    Replies: 0
    Last Post: 05-05-2013, 09:41 PM
  4. Replies: 2
    Last Post: 10-28-2012, 09:38 AM
  5. Cub Cadet LT 1042 Lawn Tractor/PTO Clutch
    By Jay E in forum Cub Cadet L&G
    Replies: 8
    Last Post: 06-17-2009, 02:24 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© 2013 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.