scoops
Bronze Member
I felt a little embarrased yesterday. I went to lift a piece of equipment on to a trailer, and the factory loader would not lift it, about all i can lift is my mmm with it.
With that said, does anyone know how to adjust the relief pressure?
I am going to throw some weights in the bucket and test it again to see where it stops lifting, but that equipment I was lifting could not have been more than 500 lbs, and I think the loader is rated about 750.
With that said, does anyone know how to adjust the relief pressure?
I am going to throw some weights in the bucket and test it again to see where it stops lifting, but that equipment I was lifting could not have been more than 500 lbs, and I think the loader is rated about 750.