Results 1 to 4 of 4
-
12-29-2012, 11:06 AM #1Bronze Member
- Join Date
- Dec 2008
- Posts
- 72
gtx2154le w/snowblower
Took out my gtx2154le with 48" snowblower out yesterday. It blew great then it snapped the belt to the snow blower. went back to dealer and was given a new belt. Put new belt on. Ran blower for about another 15-20 minutes and belt snapped again. Dealer came and picked it up today. (Of course, it's snowing again.) Has anyone else had this problem?
-
12-29-2012, 01:46 PM #2New Member
- Join Date
- Mar 2011
- Posts
- 7
Yes, I snapped 2 belts the same way. The tractor only had 12 hours on it. I took out the tractor 3 times so far this winter to snow blow and each time I could not finish snow blowing. Got pissed and traded it in for an yanmar Sc2400. I showed have my new tractor early next week. Oh... My old tractor with all the problems is a 2012 cub cadet gtx 2000. It's a great tractor for mowing a lawn but not for snowbliwing.
-
12-29-2012, 07:45 PM #3Bronze Member
- Join Date
- Dec 2008
- Posts
- 72
Re: gtx2154le w/snowblower
i am almost thinking if there is a replacement belt made out of kevlar?
-
01-01-2013, 02:03 PM #4Bronze Member
- Join Date
- Dec 2008
- Posts
- 72
Re: gtx2154le w/snowblower
Got my tractor back Monday. Problem was with pulley alignment. Dealer made adjustments and put new belt on. Tryed it out when I got it home and it seems fine. All is good. Will let everyone know if situation changes. By the way, dealer was great.
Similar Threads
-
3-Point Hitch Changing a JD 59" front snowblower into a 3pt snowblower
By biyou in forum John Deere Owning/OperatingReplies: 6Last Post: 11-23-2008, 07:57 AM -
3 pt snowblower
By chefirv in forum Owning/OperatingReplies: 6Last Post: 01-22-2008, 05:20 PM -
Snowblower
By classic in forum John Deere Owning/OperatingReplies: 19Last Post: 11-12-2007, 10:45 AM -
Front snowblower vs. rear snowblower
By BlacknTan in forum Kubota Owning/OperatingReplies: 6Last Post: 07-23-2006, 05:02 PM -
Snowblower Snowblower
By Anonymous Poster in forum AttachmentsReplies: 14Last Post: 03-03-2003, 09:17 PM


Reply With Quote
