SLM1294
New member
After using my back blade to clear snow for one season it was clear that being able to change the blade angle from the seat would make the job alot easier. I first drew up the blade on the computer and decided where to attach the cylinder. I then designed the brackets to attach the cylinder to the plow without welding. The rear bracket is kind of a sandwich that is held onto the plow with two clevis pins using existing holes in the plow. This bracket is made to fit on either side of the plow so that it can be rotated 180 degrees if desired. It can also be removed, along with the cylinder, and the original pin still used.
This seems to work well and I am looking forward to trying it out on some snow next season.
This seems to work well and I am looking forward to trying it out on some snow next season.