Increasing bucket curl (rollback angle)

[Desert Bred]

View attachment 344635

How could i increase the curl by changing the pin holes here? anyone done this?

Also.. any danger in welding on the underside of the tractor (back axle)?

 

[kg7il]

I am getting an "Invalid Attachment" error message on your link.

 

[bcp]

I am getting an "Invalid Attachment" error message on your link.

Maybe that is a comment on his bucket problem.


Bruce(waiting for a good attachment)

 

[Desert Bred]

LOL

the blue will be new lower bracket position.

 

[Desert Bred]

Update: That didn't work. Looks like the cylinder hole needs repositioning too. Will try this setup.

 

[bandaidmd]

If you want more rollback the lower pin needs to go forward but if you change it to much it may not go to vertical in the dump position.

 

[chim]

It looks like the bucket doesn't extend very far up/forward. If you increase the rollback, it may take a little more attention to the bucket position when lifting a load high to prevent dumping material off the back and onto your hood.

 

[john_bud]

Have you thought about converting to a 4 link at the bucket? They give more roll back AND more dump angle too.

 

[Desert Bred]

Hey JB- thanks for that i never even heard of it. i'l check it out.

I did try the repositioning of the holes like the first pick and it works much better about 5 inches back from the original.

edit- i looked for 4 pin hole bucket on line and came up empty thus far..

 

[Xfaxman]

Have you thought about converting to a 4 link at the bucket? They give more roll back AND more dump angle too.

Hey JB- thanks for that i never even heard of it. i'l check it out.

I did try the repositioning of the holes like the first pick and it works much better about 5 inches back from the original.

edit- i looked for 4 pin hole bucket on line and came up empty thus far..

This is what he is talking about.

Notice the extra links at the bucket.