Results 1 to 5 of 5
  1. #1

    Join Date
    Apr 2004
    Posts
    6

    Default Kubota too Gravley Mod

    I have a kubota B-5100,and a small Gravley shaft drive Tiller.I can modify the tiller too 3PTH with no problem,But should I weld a slip clutch on the shaft to protect my PTO from getting damaged.If I jam a rock in the tiller could this hurt the internal PTO drive? Thanks

  2. #2
    Veteran Member
    Join Date
    Jul 2003
    Posts
    1,969
    Location
    Kansas
    Tractor
    2003 BX2200

    Default Re: Kubota too Gravley Mod

    I wouldn't weld it, but if you can bolt a slip clutch on that would be best.

    Ron

  3. #3

    Join Date
    Apr 2004
    Posts
    6

    Default Re: Kubota too Gravley Mod

    I have a square shaft on the gravley,and a round, off the pto,

  4. #4

    Join Date
    Jul 2003
    Posts
    85
    Location
    NW Washington State
    Tractor
    Bolens hydro, BX22, 1952 MM RTU

    Default Re: Kubota too Gravley Mod

    Keep us posted on how it works out. I have a Bolens cat 0 tiller I'd like to mount on my BX20...

  5. #5

    Join Date
    Dec 2003
    Posts
    88
    Location
    West Virginia
    Tractor
    Kubota L3400

    Default Re: Kubota too Gravley Mod

    What if you went to TSC and bought a spline adaptor. Male side matching your tractor. And slide the female end over the gravely square shaft and welded that? Then you could just couple the slip clutch to the tiller. Etc, Etc. That way the slip clutch could possibly be used on other attachments also?? Just a thought.
    Dave

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© 2013 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.