Added Remote to FEL...

I started gathering parts and info for this project last year, today I finally got it installed.
Here is the Electric Diverter Valve from the Surplus Center all painted and ready to mount.



PS. this is my first post with pictures so bear with me!

This is the coupler mount that I made to mount on the loader arms.

This project is for a snow plow that I am making also, I needed a remote to operate the angle of the plow. I may also build a grapple for the bucket in the future.

Here is the Diverter mounted to the inside of the right mast, the is still plenty of clearance to get the loader on and off.

Here is the couplers mounted up front on the loader arms. The plumbing follws the same route as the existing lines.

Here is a view from behing the loader...

Here is a view from the front. It is getting dark so the picture quality is not the best...Sorry!

Here is a gauge I put together for testing the relif valve pressure, It was dead on spec!

I still have to wire the switch on the tractor and install a relay for this and future ROPS lights. The relay will protect the ignition switch from overheating.
I will post more pics when this is done and show the loader on the tractor.

Thanks to all those who helped me do this by just sharing thier knowledge and experience with this board [img]/forums/images/graemlins/wink.gif[/img]

Hey Kenny !
Nice looking job . What is the part # of the valve ? Would you mind sharing your cost to do this ?
BigAl

Sure BigAl, I guess I should have put this in the original post...

Total cost for the project is about $300.00 or so...

Here is a link to the Diverter at the SurplusCenter