Results 1 to 1 of 1
03-12-2013, 11:56 AM #1
- Join Date
- Jan 2012
- John Deere AR, a # of Farmalls, AC WD45, couple of Fords and a Massey Harris
Internatioal 544 gear oil level checking
I have a 544 International with a 4cyl diesel engine. Manual (non hydraulic) transmission with a Torque amplifier.
I can't find the place to check the gear oil in the transmission/ rear axle.
I don't know if it is covered over in dirt and I can't see it but I have not been able to find one.
Can anyone tell me where to look? right side left side back end???
I found the plug to check the hydraulic fluid on the left side of the tranny case. It is an "inny" 3/8 pipe plug.
Where the heck is the pipe plug to check the trans heavy oil?
By RMatty in forum Kubota Owning/OperatingReplies: 5Last Post: 06-14-2012, 07:46 AM
Oil & Fuel Checking transmission oil level for GC2310By kentmatlack in forum Massey Ferguson Owning/OperatingReplies: 2Last Post: 05-01-2012, 11:40 PM
By Racer11 in forum Kubota Owning/OperatingReplies: 2Last Post: 01-13-2012, 11:22 PM
By Mosey in forum New Holland Owning/OperatingReplies: 5Last Post: 10-17-2002, 08:16 PM
By Den in forum Oil, Fuel & LubricantsReplies: 8Last Post: 05-12-2001, 08:19 PM