Results 1 to 2 of 2
  1. #1
    New Member
    Join Date
    Sep 2013
    Posts
    7
    Location
    OxfordMills Ontario
    Tractor
    Looking

    Default INTERNATIONAL UTILITY 350 Hydraulics not connected "need help"

    I looked at the above last night and the seller showed me a hydraulic pump and a long double tube that he said mounted between the distributor and motor, and the tube connected to the pump and ran up to connect to the tank under the seat.
    Does any one know if this is correct and does any one have drawings of how the pump mounts?

    thanks
    Dave
    Last edited by bigrigford; 09-11-2013 at 07:56 AM.

  2. #2
    Silver Member
    Join Date
    Feb 2001
    Posts
    127
    Location
    Slate Lick, Armstrong Co, PA
    Tractor
    International 300 Utility, BX2200

    Default Re: INTERNATIONAL UTILITY 350 Hydraulics not connected "need help"

    The pump mounts between the motor and distributor. The lines should go from the bottom of the pump to the tank under the seat. There are some parts diagrams that might help at caseih dot com. The front of the pump should have a gear that meshes with the timing gear train . The rear of the pump should have a hub that mates to a drive tang on the distributor housing. These pumps cost about $700 if it is bad.

Similar Threads

  1. Deere 2210 with 62" deck and FEL 350 hours
    By h8hoos in forum Private Party Ads
    Replies: 1
    Last Post: 08-13-2013, 04:13 PM
  2. Replies: 6
    Last Post: 01-25-2011, 07:05 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© 2014 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.