Results 1 to 1 of 1
03-11-2013, 10:08 PM #1
8n Rear axle bearings
Ok so I replaced the inner and outer seals on my 1950 8n. I found out my hubs were worn so I replaced those too. I've done the axle pre load with the shims according to the FO manual so the hubs turn in opposite directions. What I'm not clear on is how tight or how hard should it be to turn the rear hubs when I put them back together? I have to use both Hands and put a little more effort into turning the hubs than I thought would be normal. Do I have the bearings too tight? Maybe I need to add another shim on the litter race?
03-11-2013 10:08 PM # ADSAdvertisement
- Join Date
- Mar 1998
- Register now to remove this ad.
By Teleskiah in forum Parts/RepairsReplies: 3Last Post: 11-01-2012, 10:39 PM
By AlanB in forum Trailers & TransportationReplies: 10Last Post: 08-14-2012, 11:32 PM
By Baybunch in forum New Holland Owning/OperatingReplies: 1Last Post: 06-26-2011, 03:25 PM
By ChucknSc in forum Bobcat Construction EquipmentReplies: 0Last Post: 04-03-2011, 05:48 AM
By Sully2 in forum AttachmentsReplies: 23Last Post: 07-27-2006, 06:05 PM