brin
Super Member
I spent 1 & 1/2 hrs. yesterday changing the three blades on my 46 inch mower deck...I will not wait 2 yrs. to do it again. I could not believe how worn down those blades were. I started leaving strips of uncut grass as I cut. I used a floor jack to jack the tractor up and had to use an air ratchet to get the blades off..the mower deck had a dent in it so one of the new blades would not fit..Uggg ! So had to take a hand sledge and hammer that out but otherwise it went smooth as can be.
It is too bad the manufacturers can't come up with a better design to make it easier to change blades. The manual says to take the mower deck off..imagine going through that just to change the blades.
It is too bad the manufacturers can't come up with a better design to make it easier to change blades. The manual says to take the mower deck off..imagine going through that just to change the blades.