Not sure if this belongs in this forum, but I'll give it a whirl.
I have a portable generator that starts immediately with starting fluid and then dies when the fluid is gone. I took the carb apart and noticed the float and float pin was sticking, so I jiggled them and they are working freely now.
The bulb fills up with gas, but I can't figure out what else might be preventing fuel from reaching the engine.
Any suggestions?
Appreciate the help.
I have a portable generator that starts immediately with starting fluid and then dies when the fluid is gone. I took the carb apart and noticed the float and float pin was sticking, so I jiggled them and they are working freely now.
The bulb fills up with gas, but I can't figure out what else might be preventing fuel from reaching the engine.
Any suggestions?
Appreciate the help.