Doing an engine rebuild and wanted to check on the type of sealants I should use?
1. Head Gasket (think it is made of copper)
2. Rear Oil Seal Housing to block/bearing cap...this has a rope seal, but the manual says to use a sealant for the gasket between the housing and block/bearing cap.
3. Oil Pan
I just wanted to make sure I did this correct...thanks.
Also, the manual says I should properly lubricate the main bearings when I install them...are they talking about luricating on the both sides of the bearing insert before I place them in the bore areas on the cap and block, or should I install them dry, then put some lucas on them? Any help would be great...thanks.
1. Head Gasket (think it is made of copper)
2. Rear Oil Seal Housing to block/bearing cap...this has a rope seal, but the manual says to use a sealant for the gasket between the housing and block/bearing cap.
3. Oil Pan
I just wanted to make sure I did this correct...thanks.
Also, the manual says I should properly lubricate the main bearings when I install them...are they talking about luricating on the both sides of the bearing insert before I place them in the bore areas on the cap and block, or should I install them dry, then put some lucas on them? Any help would be great...thanks.