Hydraulic adds

   / Hydraulic adds #1  

6sunset6

Veteran Member
Joined
May 6, 2007
Messages
1,056
Location
SE NY
Tractor
NH TC34DA 34HP HST, 2 rear remotes, front diverter, loaded R4's
I guess this belongs here. One rear remote . Added a diverter valve to run angle plow up front and snow blower chute in the back. Front also runs a thumb in the summer.
First attempt at pictures.
 

Attachments

  • IMG_3475.JPG
    IMG_3475.JPG
    912.4 KB · Views: 719
  • IMG_3476.JPG
    IMG_3476.JPG
    813.4 KB · Views: 536
  • IMG_3477.JPG
    IMG_3477.JPG
    853 KB · Views: 431
  • IMG_3478.JPG
    IMG_3478.JPG
    962 KB · Views: 404
  • IMG_3479.JPG
    IMG_3479.JPG
    732.1 KB · Views: 418
  • IMG_3480.JPG
    IMG_3480.JPG
    915.6 KB · Views: 450
   / Hydraulic adds #2  
Welcome and nice job! I like the hoe rack on the back. Any problems plumbing the lines?
 
   / Hydraulic adds
  • Thread Starter
#3  
No problems plumbing except running out of fittings. Also could not decide on R1 or R2 hose. Had some of each. R2 is way over kill but much more robust. I use reusable hose ends and they are hose size specific. I wish I had a crimper $1000 and could use crimp fittings. There are more types available and they are cheaper.
There is a shovel above the hoe. It's nice , they go where I go.
 
   / Hydraulic adds #4  
Nice setup for the snowblower. Although I use a hydraulic motor and mine spins 360 degrees, cause I like to shoot myself in the face every once in awhile. :D
 
   / Hydraulic adds #5  
Nice clean install. That's a high dollar hoe holder you have there (copper pipe?).
 
   / Hydraulic adds
  • Thread Starter
#6  
Don't know where to put this so might as well use my own thread. It could go 6 other places.
Agricultural Tractors & Equipment - ABC Groff, Inc
Go to this web site and look at Fasse valves.
Probably cost like they were made at Fort Knox but what a clean package.
 
 
Top