npaden
Platinum Member
I have a line on an extra joystick loader valve with all the trimmings. I was thinking that I could use this for 2 rear remotes pretty easily. It is going to be a little bulky, but I was thinking I could figure out a way to get it mounted where it wouldn't be too much in the way.
Am I missing something here, would there be any big pros or cons to using a loader valve for rear remotes? I was thinking it would be nice for a top and tilt setup as you could run it with a single joystick.
Thanks, Nathan
Am I missing something here, would there be any big pros or cons to using a loader valve for rear remotes? I was thinking it would be nice for a top and tilt setup as you could run it with a single joystick.
Thanks, Nathan