Results 1 to 2 of 2
  1. #1
    New Member
    Join Date
    Jul 2011
    Case IH 2294

    Default Case IH 2294 Hydraulics Failure

    Case IH 2294 Farm Tractor - Problem is the tractor hydraulic rear remotes,
    3-point lift, and clutch stopped working. Tractor does have power steering if you can finally get it in a gear and moving.

    Would the hydraulic system charge pump cause this? I have oned this tractor about 4-years and looks like the main pump and charge pump have been replaced before my mistake of purchasing the tractor.

  2. #2
    Gold Member TraderMark's Avatar
    Join Date
    Feb 2001
    Southeast Georgia
    Ford 1720

    Default Re: Case IH 2294 Hydraulics Failure


    I've been studying on your problem for a couple days now and I think your problem lies in the charge pump drive.

    The 2290, predecessor of the 2294 used to have a tendancy to either strip out the torque limiter disc on the flywheel or strip out the right angle drive that powers the main hydraulic pump and the charge pump.

    If the torque limiter disc was slipping or the hub was spun out of it, there would be nothing to drive the pumps at all and since you say you have steering, I have to assume that the small gear pump that's piggy backed on the main hydraulic piston pump is turning. BTW, do you have brakes too? If you have steering, you should also have brakes.

    The charge pump is driven by nothing more than a 7/8x 3/16 wwodruff key. Chances are, that key has sheared and the charge pump is not turning and not supplying oil to the main hydraulic pump.

    There's usually a reason for a key that shears, they don't usually just snap on their own, so you should check that the charge pump isn't seized internally.

    You can click here, then click on Hydraulics, then Charging Pump and Drive. The woodruff key is item #9.

    I think .... and again, I'm not CERTAIN, but I think you can remove the charge pump and its drive without splitting the tractor.

    Hope this helps.

    1720 Ford 4x4 w/ 7108 FEL
    Case 1845 Uni-Loader NO it's NOT a "C"
    190C John Deere
    Various implements, some store bought, some home made.

Similar Threads

  1. case 446 PTO, hydraulics and 3ph
    By JProcken in forum Case / Ingersoll
    Replies: 15
    Last Post: 06-10-2011, 06:29 PM
  2. Comparison Is the NH TZ25DA identical to Case IH DX25E
    By wesnospam in forum New Holland Buying/Pricing
    Replies: 0
    Last Post: 05-08-2011, 10:49 AM
  3. Spring Equip Auction - Central NY
    By JJT in forum Related Topics
    Replies: 12
    Last Post: 05-04-2011, 07:47 AM
  4. Buying Advice Case IH 4210
    By ah64_ip29 in forum Case-IH
    Replies: 0
    Last Post: 08-16-2010, 12:51 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
© 2018 TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.