tn70 hydraulics
- Thread starter jrc121
- Start date
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,928
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
The pump shaft just might be damaged.
Have you taken any pressure readings?
Have you removed a hose and placed in a bucket to see if the pump was pumping?
Are there any QD's involved.
Is the tank fluid at the proper level.
Is the right fluid installed.
More info from you might provide more answers.
Have you taken any pressure readings?
Have you removed a hose and placed in a bucket to see if the pump was pumping?
Are there any QD's involved.
Is the tank fluid at the proper level.
Is the right fluid installed.
More info from you might provide more answers.
Last edited:
Thanks J J
Fluid level seems good
Have not changed the fluid and it was working
No pressure readings
When I operate the lever for the loader nothing at all happens like there is no pressure at all, that's why I was wondering if there was a way to disengage the hydraulics that I don't know about.
Fluid level seems good
Have not changed the fluid and it was working
No pressure readings
When I operate the lever for the loader nothing at all happens like there is no pressure at all, that's why I was wondering if there was a way to disengage the hydraulics that I don't know about.
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,928
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
Remove one of the cyl hose and see if the pump is pumping.
The pump shaft may be damaged and just spinning doing no work.
The pump shaft may be damaged and just spinning doing no work.
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,928
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
You may have lost prime.
pafarmgurl
New member
As I recall, New Holland had a notice on the TN70 or TN70A (Unsure of tractor year(s) that it covered. The pump shaft that connect to the shaft in the front right corner of th engine was too tight and would twist off when it binds too much. The notice called for a smaller shim or something. But after it occurs, I believe they had to replace the pump due to the shaft being twisted off. Let's hope its not that.