CCOUGHRAN1
Silver Member
- Joined
- Jun 22, 2006
- Messages
- 193
A couple of weeks ago I purchased some Rhino Magnum 15 batwing mowers. They had been sitting for some time, and there was some rust and pitting on the exposed wing cylinders. I tried to sand/polish them, but they just had too much pitting, and now they are not holding their position any more.
Looking at the Rhino specs, it says they are a 3x14" with 1.25" shaft. All of my lines are setup for 1/2NPT ports.
I found what appears to be a good replacement cylinder at Surplus Center.
Surplus Center - 3X14X1.25 DA HYD CYL W300140
Is there a better source, or possibly a better cylinder that I need to be looking at?
Thanks,
Chris
Looking at the Rhino specs, it says they are a 3x14" with 1.25" shaft. All of my lines are setup for 1/2NPT ports.
I found what appears to be a good replacement cylinder at Surplus Center.
Surplus Center - 3X14X1.25 DA HYD CYL W300140
Is there a better source, or possibly a better cylinder that I need to be looking at?
Thanks,
Chris